Cable Glands

Cable Glands

These cable glands provide a clean and secure way to route cables through controller enclosures while helping protect cable entry points from water, dust, and the elements.

Available in PG7, PG9, PG11, PG13.5, and PG19 sizes, they accommodate a range of cable diameters commonly used in animated light displays. The compression design grips the cable as the gland is tightened, providing strain relief and helping keep wiring securely in place.

PG9 is particularly well suited for our xConnect pigtails and 18 AWG power cords, making it a great choice for pixel outputs and power connections on controller enclosures.

Available sizes

• PG7 (Pack of 5): Cable diameter: 3–6.5 mm
• PG9 (Pack of 5): Cable diameter: 4–8 mm
• PG11 (Individual): Cable diameter: 5–10 mm
• PG13.5 (Individual): Cable diameter: 6–12 mm
• PG19 (Individual): Cable diameter: 12–16 mm

Choose the appropriate gland based on the outside diameter of the cable being installed.

Specifications

• Gland rating: IP68
• Compression-style cable seal
• Locking nut for enclosure mounting
• Suitable for indoor and outdoor installations
• Available in multiple sizes for different cable diameters

Typical use cases

• Pixel controller enclosures
• Power supply enclosures
• Pixel output pigtails
• AC and DC power cable entry
• Differential receiver boxes
• Network and data cable entry
• Custom outdoor light show enclosures

Installation

Install the cable gland through a properly sized hole in the enclosure and secure it using the included locking nut. Pass the cable through the gland and tighten the compression cap until the cable is held securely in place.

For the best fit, measure the outside diameter of your cable and select a gland with a clamping range that accommodates that diameter.

Included

PG7 and PG9:

• 5 × IP68 cable glands
• 5 × locking nuts

PG11, PG13.5 and PG19:

• 1 × IP68 cable gland
• 1 × locking nut

Notes

• PG7 and PG9 are sold in packs of 5
• PG11, PG13.5 and PG19 are sold individually
• Enclosure, cables, and pigtails sold separately
• PG9 is recommended for our xConnect pigtails and 18 AWG power cords
• Measure the outside diameter of your cable before selecting a gland size
• Ensure the gland is properly installed and tightened around the cable to maintain the intended environmental protection